secure-ntp: label /run/chrony-dhcp so chronyd can read the NTS source under SELinux

Second bench defect after removing the distro 20-chrony-dhcp clobberer
(secure-ntp-5a3eaed, comet-beacon-54): the dispatcher wrote the correct
`server ntp.fleet.lab iburst nts` line, but chrony loaded ZERO sources --
`chronyc reload sources` returned 200 OK yet authdata/sources stayed empty.

Root cause (AVC): chronyd_t was DENIED read on the .sources files because they and
/run/chrony-dhcp itself were labeled generic var_run_t; chronyd_t may only read its
own chronyd_var_run_t. The dispatcher's `mkdir -p` creates the dir as var_run_t and
files inherit it. The distro 20-chrony-dhcp we removed had been restorecon-ing them
to the readable label, so removing it exposed a latent labelling gap.

Stock RHEL policy already maps /run/chrony-dhcp -> chronyd_var_run_t (a restorecon
relabels it and chrony immediately reaches NTS Cook 8). Fix: ship
/etc/tmpfiles.d/chrony-dhcp.conf so systemd-tmpfiles pre-creates the dir with that
fcontext at sysinit, before any NM event -- the dispatcher's files then inherit
chronyd_var_run_t and chronyd can read them. No SELinux allow rules needed
(bench-verified: after the fix a real NM event wrote the source as chronyd_var_run_t,
no AVC, authdata -> NTS Cook 8). Applies in both secure_ntp modes.

Also: the dispatcher now skips `lo` -- it was writing a spurious lo.sources
duplicate of the same server (the distro script had skipped loopback).

BENCH-VERIFY on the next clean build: a normal boot leaves the source file labeled
chronyd_var_run_t (ls -Z), no lo.sources, and authdata reaches NTS/cookies>0 with no
manual step.

files/etc/NetworkManager/dispatcher.d/10-chrony-dhcp-ntp

@@ -27,7 +27,11 @@
 # /usr/lib/NetworkManager/dispatcher.d/20-chrony-dhcp writing option-42 servers to
 # the SAME <iface>.sources. NM merges /etc + /usr/lib sorted by name, so it runs
 # AFTER us and would clobber the NTS line — the provisioner removes it (it defeated
-# NTS on the bench: chrony fell back to plain NTP). This script supersedes it.
+# NTS on the bench: chrony fell back to plain NTP). This script supersedes it. It
+# was ALSO (accidentally) labelling the sources chronyd_var_run_t so chronyd could
+# read them; we restore that via /etc/tmpfiles.d/chrony-dhcp.conf (see the dir note
+# below) — without it, under enforcing SELinux chronyd can't read the sources and
+# loads nothing (bench 2026-07-12).
 
 MODE="@NTP_MODE@"      # nts | dhcp
 PREFIX="@NTP_PREFIX@"  # nts: server name = <PREFIX>.<dhcp-domain>
@@ -40,6 +44,15 @@ case "$action" in
     *) exit 0 ;;
 esac
 
+# Loopback carries no DHCP NTP config; acting on it just writes a spurious
+# lo.sources duplicate of the same server (the distro 20-chrony-dhcp skipped lo —
+# we must too, or chrony sees two files for one server). Skip it.
+[ "$interface" = lo ] && exit 0
+
+# /run/chrony-dhcp is pre-created with the chronyd_var_run_t SELinux label by
+# /etc/tmpfiles.d/chrony-dhcp.conf at boot, so the files we write below inherit a
+# label chronyd_t can READ (else, under enforcing, chronyd is denied and loads no
+# sources — bench 2026-07-12). This mkdir is just a fallback if tmpfiles didn't run.
 dir=/run/chrony-dhcp
 file="$dir/${interface}.sources"
 mkdir -p "$dir"

files/etc/tmpfiles.d/chrony-dhcp.conf

@@ -0,0 +1,22 @@
+# Pre-create chrony's runtime NTP source directory with the CORRECT SELinux label
+# at boot, before any NetworkManager event fires. The NM dispatcher
+# (10-chrony-dhcp-ntp) writes <iface>.sources here for chronyd's
+# `sourcedir /run/chrony-dhcp`.
+#
+# Why this exists: the dispatcher's own `mkdir -p /run/chrony-dhcp` creates the dir
+# as generic `var_run_t`, and the source files inherit it — but `chronyd_t` is only
+# allowed to read `chronyd_var_run_t`, so under enforcing SELinux chronyd is DENIED
+# reading them and silently loads ZERO sources (bench 2026-07-12, comet-beacon-54:
+# NTS never activated — `chronyc authdata` empty; AVC `denied { read } … chronyd_t
+# … var_run_t`). The stock RHEL policy already maps /run/chrony-dhcp →
+# `chronyd_var_run_t`, and systemd-tmpfiles applies that fcontext when it creates
+# the dir here at sysinit (well before the dispatcher runs). Files the dispatcher
+# then creates inside inherit `chronyd_var_run_t`, so chronyd can read them — no
+# SELinux allow rules needed (verified on the bench).
+#
+# The distro chrony NM dispatcher (/usr/lib/.../20-chrony-dhcp) used to apply this
+# label via a per-file restorecon; we removed it because it clobbered our NTS source
+# (see diskless.pkr.hcl + the 10-chrony-dhcp-ntp header), so we restore the labelling
+# here instead. Needed in BOTH secure_ntp modes (chronyd must read the sourcedir
+# either way).
+d /run/chrony-dhcp 0755 root root - -